Search:
Type: Posts; User: bioray
Search:
Search took 0.00 seconds.
-
I agree with smoothy. That has happened to me before and it was indeed the key on the flywheel.
-
Not getting enough fuel. The main jet might have dirt in it. The float might need to be adjusted to keep the engine from starving.
-
I am having a new house built. What are the pros and cons of venting or not venting a stove vent hood. I always thought that you should vent the hood to remove excess heat and odors (and occasional...
-
You might want to cut the ends off and get a quick disconnect fitting kit.
-
You might want to cut the ends off and get a quick disconnect fitting for each end.
-
Thanks for the info... I usually change the oil twice a yr. once about mid season and once after I finish chopping up leaves in the fall.
-
I would like some opinions on ceiling fan brands. I have been a fan (ha ha) of hunter fans for years. I am now building a new house and will be purchasing several fans. Are hunter fans the best...
-
Cheap is right! Wait till he replaced the smoking worn out engine while my honda with synthetic oil and spin on oil filter is humming right along:):D
-
I searched, I looked, and I was informed.
That is a change from my manual. I need to check the serial numbers, but for most it says 10w30 is good for general use. 10w30 is a lot easier to find...
-
Thanks,
I will take a look.
-
My engine is only 3 or 4 years old.
-
I would have to recommend the drilling method as well. Burning the handle out could ruin the temper of the steel of the axe head
-
The user manual suggest using straight 30 for temps above 30c. It is well over 30C when cutting grass in the summer in Alabama! I think using synthetic over conventional could lower my engine temp.
-
Try melting the pull cord end with a match or a lighter. That has worked for me in the past.
-
What is your thought on using 30 weight synthetic oil in a small air cooled engine? I have a snapper rider with a 13hp honda engine.
-
The grinding wheel should be checked for tightness. The grinding wheel should be dressed with a dressing tool if the wheel is not flat on the face. Ensure that the tool rest are properly adjusted...
-
What engine is on your snapper? Most small engines do fine with SAE 30 weight oil.
-
I am in the beginning stages of home construction. Would it be better to install a sewage pump in the basement foundation or outside? What would be the most ideal location?
Thanks for your help!
|