Search:

If I was to do this, I would add a separate box with a GFI receptacle.

I didn't think about the 30 amp breaker that controls the A/C circuit, it's a very good point. I can add a breaker in my...

Is it within code to tap into an A/C disconnect box (240v) or hot tub disconnect (240v) and add a 120v GFCI outlet?

I know it can be done, but there may be potential risks that I am not aware of. ...

You usually have to erase all the codes in the garage door logic board usually located on the back of the motor.

The openers I am familiar with are fairly simple. You push and hold the button on...

I am building a cinder block wall and will be stuccoing the exterior part of the cinder blocks. On houses, a vapor barrier is put up, then chicken wire, then a base stucco coat. After it has cured,...

I went to the ICC website because I need to get an IBC code book. I have no idea what I would need though. They have the I-Code set for $680.50 but I am wondering if that is overkill.

I do a...

There is a locking coupler on the Whirlpool washing machines that locks when it kicks into spinning cycle. I am guessing here, but if you try and run it without any clothes in it, it will probably...

It could be several problems. One problem could be the timer. More likely though, it sounds like the motor/pump is ceased or has gone bad. The water is filled through a separate valve and has...

That's what I was afraid of. It wouldn't be a big deal but man copper is expensive right now! I have lots of 14 gauge, but no 12 gauge... go figure. ;)

I know that a 20 amp breaker and a GFCI plug are required in a bathroom. Does this mean the wire size has to be 12 gauge or can it be 14? If I wire the bathroom lights on the same circuit, can I...

I am building my basement right now and have been reading about wiring and circuits. I thought I had everything figured out for my basement until I started looking into my lighting circuit today. I...