Search:
Type: Posts; User: Nutter butter
Search:
Search took 0.00 seconds.
-
Don't get flat. I hate mine ,with the light just right you can see every little scratch of flaw. Use something that is wavy, It will be more expensive though, anything but flat. If you like light...
-
I would use Hammer drill with a masonry bit and drill holes into the side of the existing concrete. Then put the re-bar in the holes. Make the holes somewhat across from each other so you can tie...
-
If you can't drive a caulking gun very well you can buy at in a roll at any home store. Just peel of the paper and stick it down.
-
Try 2 part epoxy paint. Found at any paint store.
-
NO it won't. If the inlet and outlet is at the top.
-
Beware of only 9 x 9. Not used after 79. But you can strip and buff it all you want if it was.
-
That doesn't sound right. I have a new Kenmore and goop was not an option for my model. I would call the store you bought it from.
-
Air, oxygen, you may not have enough for the flame to stay lit. During the hot months I have to have a fan blowing toward my heater. The fan is about 8 feet away. You may need to instal a vent in the...
-
I work with some. Its really tough work. You have to read pressure gages, oh and record what you found. Other than that they rebuild motors and pumps.
-
Without the vac break you risk flooding. Mine is done like this. Make sure you turn on you disposal a few seconds before you start the dishwasher. EVERY TIME. Your sink can fill up and over flow...
-
Can you open it up. If so spray it down with a bleach and water mixture and wipe it down. Duct tape a rag to a dowel or broom handle if you have to. Air freshener will only temporarily mask the odor.
-
What the Don-f. I'm talking way past "the Basics". Monkeys can do that. Thanks for your help though. I searched for this part on line and found one place that had it, OEM 60 bucks. Part # 85112-04.
-
If you did I would keep it at least 2in below.
-
There is only one fan out wire on the receiver and 4 on the fan itself Gry,pink, red, yel. Fan mod# is 23457 the new receiver is 84368 both are Hunter. The 12 year old at Lowe's said this replaces...
-
It sounds like there is no light on the fan. Its just a fan. If it is the starting cap it might be easer just to change out the fan. If you think you can change the cap just remove it and buy another...
-
That can be a fire hazard if you do that. You have to sacrifice some things or buy a UPS (uninterrupted power supply) system for each computer. This will keep your computers on long enough to reset...
-
I think that type of system is for a separate spout just for drinking water. Usually mounted on the back of the sink.
-
This should be fine. I'm thinking gravity might be a problem. You may want to put the p trap at the old location, so the plumbing is up close to the new sink. But it may smell after awhile. If you...
-
This is driving me nuts. OK I know where the b and w wires go from the fan to the receiver also the " one " that says light out " which is red. What I have left on the receiver is Fan out and Common...
|