Search:

inject some math > a 1,000 sq.ft home... that is floor the area... a 10'x12' room w/8'walls contains 470 sq.ft. of paintable surface (4 walls & ceiling). With estimates it is usually best to get 3 to...

How old is the pine? What finish is on it now? Ya got to get the grease and if any wax cleaned off for any finish to adhere. Might try scotch brite pads and paint thinner for heavier dirt areas....

Corian is made by DuPont. Fabricators are certified and the product has an extensive warranty. Fabrication & maintenance procedures are clearly defined by DuPont. First question > Is this material...

The dust mess is why it is valuable to learn how to tape & mud without sanding or with the least possible. Sweep up as much as possible and then I would use a quality vacuum. It requires another hand...

Found the site last eve > Cardinal Shower Enclosures - Welcome < this site will locate distributors in your area who you can contact for shower door hardware... this is a division of Hoskin Muir Co....

Corian is manufactured by DuPont. Fabricators of Corian must be certified. The material has a 10 year warranty. If you are sure it is Corian, no problem contact the fabricator. Other solid surface...

www.Craigslist.org the only way to sell or give away...

Water base poly acrylic... either Minwax or Flecto.. both the same material... I have found Lacquer thinner to attack it... really sounds like wax in the base finish... sounds like a total strip &...

For a normal 30" 1/4" glass shower slider usually a top mounted track with a wheel carriage... the wheel carriage mounts by clamping onto the glass via screws... best bet is to seek out a local...

correction to my post 1 board foot = 12" x 12" x 1" .... 1 square foot by 1" thick... figure the area then multiply by the thickness

board feet measure is used in hardwood lumber... 1 boyfriend = 1" x 1" x 12".. 4/4 hdwd =1" / 6/4 hdwd =1 1/2" / 8/4 hdwd =2" etc... measue your width & length to determine square footage... then...

Avoid sanding drywall... learn to use the knives... for small jobs a 3" & 6" knives should suffice... build up the wall finish... more applcations is better than all at once... 150 grit sandpaper is...

finish nails usually suffice... the window is set into a framed opening (2x4's).. the sheetrock is face nailed to the studs... depending on the width of the trim moulding striking the stud is usually...