Search:
Type: Posts; User: BSelff
Search:
Search took 0.00 seconds.
-
Thank you, everything else I have wired 220v was always 2 hots and a common. This wire is romex which is what I am using in the walls on my shop, but I was confused with the bare ground and not a...
-
Good Afternoon,
I had a chance to acquire some 6-2 w/g and would like to know if this is okay to wire my 50 amp plug to my welder? If this is okay to use; where would the bare ground wire be...
-
I already have 2 rolls of #12 (1000 ft) at no cost, I bartered for it. My main question is putting the lighting circuit on a 20 amp breaker instead of a 15 amp. I purchased all 20 amp breakers.
Bob
-
Is there any reason I can not run #12 throughout my shop (110 only) and 20 amp breakers even for the lighting circuits if I stay within the quantity of items per circuit?
Thanks,
Bob
-
Is there any reason why I can't run #12 throughout my shop and run all circuits (even lighting) on 20 amp breakers?
-
Thank You, I am assuming my drawing is then correct? I do understand about the neutral strap to ground (box interior) not being connected to each other.
-
I received an answer prior to wiring this up, but am a bit confused. I think I was told to keep the ground separate at the sub panel but am not sure. If so, I only need to pull 3 wires (2 hot legs...
-
In your pervious response (see pdf) your answer stated to keep the neutral and ground separate at the sub-panel. Being the novice I am, does that mean I only have to pull 2 wires or do I pull 3...
-
Currently I am using a static phase converter on my LeBlonde lathe, and have just purchase a 3ph radial arm saw. I am curios about rotary converters. I have seen ads on the internet and read articles...
-
I have had them install a Eufer (ground bar attached to the rebar in the slab) in the workshop for grounding it separately.
Bob
-
I currently have a CH MBE4040B200BTS Meter main panel on my pump house drawing only power to run booster and well pumps, here is what I wish to do:
Add a CH BRS225 (feed thru) to a CH BR4040B200...
|