Search:

I've owned over 200 tractors

I have done this with every carburetor plus changed the governor arms throttle plate and springs and throttle arm it does not matter always the sameThe murray must have different jets in carburetor....

Check fuse under steering on right side .

What type of motor ?

A friend didn't check oil and blew 11 briggs on Dixon Zero. Where can I find 11HP
Briggs with exhaust on carb and air cleaner side. Never saw one before.

Did you take off rear tire and lose key

Is your flywheel plastic or metal. Might have wrong starter

Once had one with bad carb solenoid wireing. Somehow once got hot solenoid shut tractor down. Did everything so we cut the needle off solenoid and put shut off valve on fuel line. We changed...

Breaks on both pulleys. If they don't work belt gets all messed up

go to nearest reputable lawn equipment parts and dealer. Xmark Z trans fluid works great

Check gas cap make sure it can breath. Also check oil. Older carbs needle valves wear out gets gas in oil.

Most key switches for all brands are the same. AYP - Murray used same make switches.
Craftsman Were built by Murray and AYP

You can put any engine you want in there. Any kohler will work. I have changed 17 teens for 15.5s Heck find 15.5 to 16.5 Somewhere try to find used. Older Kohlers run for ever.

You never should cut that low.

Blade engage safety switch also might be sticking

It matters how old. You have a cable newer or rod older which ingages the blades.
A three inch spring is either from a blade brake newer deck or the very front. There
Is a hole in front middle to...

It depends how old it is newer models have a high and low adjustment for carb older models have just one .New ones have two round adjustment knobs. High on right low on left. Use red wire connector...

Original carb was wasted. Put three different carbs from craftsman tractors
No matter what I do all I can get is smooth Idle did everything governor
Adjust different fuel solenoids always the same....