Yet another "closet flange is too high, what to do" question
OK... let me first say thanks again for all the prior help.
What's there:
Concrete floor
3" cast iron
Lead pipe connecting closet flange to closet el
Brass closet flange will end up at 1" over fininshed floor...
Ok... so I used a small, sharp screw driver and hammer and worked the inisde edge of the lead away from the flange... I slipped the flange down to the top of the concrete...
Now what do I do... do I just re work the lead around the inside of the flange until it's as tight as I can get it, working the edge over the lip of the flange, then trim off the excess?
Or do I have to solder that lead inside edge to the flange..
I couldn't tell when prying if it was just hammered or also soldered...
Thanks again for all your help