I have a Model #665.15892100 Kenmore dishwasher with a fault code not listed in my manual and NO ONE at Sears can answer me as to what this fault code means! I have a non Sears tech working on it for me but he has never come across this code with any of the other brands (since Kenmore does not make their own) and does not have the capability to question Sears technical support. I did call their customer service and they said they can't help me. Cycles take too long to proceed to the next cycle.
:(

What is the fault code you're getting?

"j"

Boy, I've just had no luck, I'm sorry to say. All the error codes I found for Kenmore are Capital letters and/or numbers... so I can't help but think that maybe you've also got a problem with the display where that code is appearing.

I'm sorry I couldn't be of more assistance. Hopefully one of the others will come along and give a tip.

Sounds like something is messing with the board, could be the board itself.

Id hate to tell you to run and get a new board, but if your manual doesn't have a listing for it, your repair guy don't know, Sears, don't know, and RickJ couldn't find anything, it sounds like to me the board is sending some sort of spoof reading to the diplay.

Ive seen our commercial undercounter dishwasher do that, first we check the probes, probes that are not reading right, or misfiring cause the board to display wild messages, once all other avenues have been explored we replace the board and hope for the best.

Of course our dishwashers use probes to detect water level and give a temp reading at the sump, I doubt a temp reading is nessesary for a residential dishwasher, and you probobly use a simple float for water level. Im suspecting the board. But as Im not sitting in front of it, Id go with any advice your repair man gives first.

Oh, check for loose or corroded wires, anything that doesn't look normal, check it out. Water may have leaked over an wire that carries data causing some strange probems. On mechanical dishwahsers this would just most likley throw some sparks around, but on low voltage control board circuits, it will most likley just make strange things happen. Check the board to see if its wet, check for burned marks or discoloration on the board.

It sounds like a temp switch. On certain cycles it will turn on the heater and wait for the temp (normally 140) then continue. If one of those is bad then it will time out on the control board. Try running it with all water temp settings off and see if it complete the cycle with out errors.

Quote:

---

Originally Posted by Kender

It sounds like a temp switch. on certain cycles it will turn on the heater and wait for the temp (normally 140) then continue. If one of those is bad then it will time out on the control board. Try running it with all water temp settings off and see if it complete the cycle with out errors.

---

I honestly didn't think that residentual dishwashers did that. Of course Im not saying they don't, after all, my dishwasher is rather old and all mechanical (no boards, display, etc).

But you make a valid point, if it does have a control board then I certainly wouldn't rule it out.

What you just said sounded like it was torn from the pages out our service manuals for the commercial undercounter dishwashers. Depending on the setting, it will wait until a certain temp is reachd in the sump before it exits "fill" mode, and then you can wash.

Most states want water heaters installed with a temp setting of 125 for scalding but it does not wash the dishes very well. So now the dishwasher manufactures have started adding that feature into the residential washers

Interesting, and thank you for that bit of information, I'll keep that in mind.

I guess Im going to have to upgrade my appliances to keep up! :)

Of course I can't see that happening anytime soon since I boxed my dishwasher into that hole in the wall, and built shelves all around it. :)

Of course then I'll be getting J errors that make me want to beat my head against the wall (haha)