Ask Experts Questions for FREE Help !
Ask
    jackb2's Avatar
    jackb2 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 16, 2009, 01:13 PM
    Symmons shower diverter spindle
    Hi,I have just replaced my Symmons shower diverter spindle again(TA-25A)because of a leak and now have a new problem. I have to replace this diverter spindle every year or so because the plastic on the end by the o-ring cracks and it leaks water down through the first floor ceiling.The problem now is that there is very little flow out the shower head,most of the water comes out the tub spout no matter where you set the diverter handle.I took it all apart again to see if I installed something incorrectly but couldn't find anything wrong and it seems to fit together only 1 way.This same thing happened one other time when I replaced the diverter spindle-I happened to have another new one on hand and even though I couldn't see anything different with the 2 new spindles,the 2nd one worked fine and I left it at that.I find it hard to believe that I have another new bad one.Does anyone have some suggestions before I pull this apart another umpteen times and see nothing wrong and then go to the plumbing supply and stock up with some more new ones?Thanks for any help,Jack.

Check out some similar questions!

How to replace Symmons diverter Handle part T-30? [ 6 Answers ]

This piece is made of plasic and broke off at the 90* neck angle. (at least it is stuck on shower mode which, if it had to break, is what I would prefer.) I have ID'd the part # but have a couple of quesitons about replacing it. First, how difficult is this for the average joe? I have a diagram...

Symmons - Temptrol Diverter [ 22 Answers ]

I have the above diverter in my bathroom. Recently it started to leak from the diverter handle that changes the use from tub to shower. I purchased the Symmons TA-25A Iverter Spindle to replace old. My problem is that I do not know how to remove the old spindle. Can anyone help me with my problem?

How do you replace the Symmons temprol diverter [ 1 Answers ]

How do you replace the temprol diverter in a Symmons single valve shower/tub assembly?

How to replace symmons spindle [ 1 Answers ]

How do you remove old symmons spinde and replace it with a new spindle and diverter Handle??

SYMMONS Temptrol leaking from diverter [ 1 Answers ]

Symmons sent the replacement seats and tools to repair a leak from the diverter hole that happens only when water is turned on. I replaced the seats, tightening by hand stopping short of cranking them. (I didn't use a torque wrench). Three times I removed them and adjusted them, but the...

View more questions Search
 

Add your answer here.