1 Attachment(s)
How best to sweat angle stop with extension?
I wanted to get advice on how to cleanly solder the Brasscraft - Supply Valves CS40B C1 Angle Valve (see pic). I see they slip over the 1/2 inch stub I have but how much overlap should I have for sweating and if it is too long do I cut the chrome covered ext tube? I wanted some expertise on how to get the best looking results before I try and mess it up. I wanted some hints on how to not burn the wall when I sweat and get it all to be coverd by the eschuchen. If someone can impart their wisdom on these matters I would be grateful.
Thank you