Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Plumbing pipe diameter
[ 3 Answers ]
Out of the pressure tank is 1" then past the pressure gauge is 1/2" throughout the house to all of the faucets. The tank pressure is 40psi. The hot water is the same. 1/2" throughout from the tank. All faucets have very low pressure. Shouldn't the line past the pressure gauge be at least 3/4" and...
Toilet vent pipe diameter?
[ 3 Answers ]
I am installing a new toilet in a remodeled bathroom. The toilet is going to be placed where I cannot instal a vent pipe greater than 1.5" diameter because of existing obstructions. I understand that a vent pipe for a toilet should be 2" diameter minimum. Will the toilet flush properly with this...
Pipe diameter
[ 3 Answers ]
Sorry I posted this in plumbing but had to move it here. I have a question about a residential two pipe boiler heating system with cast radiators. If I wanted to replace a section, or all of it, with copper is there a need to reduce the pipe diameter or should I leave it the same? Also is it...
Reducing diameter of a vent stack
[ 1 Answers ]
I am replacing a shower stall in my house and found that the 3" PVC vent stack in the wall protrudes slightly beyond the studs and is in the way of where the new pre-cast shower pan will sit. I could solve the problem by using 3" to 2" reducers to narrow the vent stack pipe to 2" dia. For about 3...
Pipe diameter = poor water pressure?
[ 1 Answers ]
My apartment has low pressure, especially in the shower. It's a loft building in NYC and my unit was renovated in 1985. Others in the building claim to have no issues with pressure. I'm re-doing one bath and the walls have been removed. While the pipes running to the shower area are large, the... View more questions Search
|