My dishwasher model KUD FBHLBT6 has "normal" and "rinse cycle" blinking lights. How do I reset?
My dishwasher model KUD FBHLBT6 has "normal" and "rinse cycle" blinking lights. How do I reset?
Try the circuit breaker. Shut it off wait a few minutes and turn it back on.
1) Crack the door open.
2) Within 3 seconds press the following sequence - Hi Temp Scrub, Energy Saver Dry, Hi Temp Scrub, Energy Saver Dry
3) Close and latch the door
4) Press the cancel button (the circle with the triangle in it)
Here's another 2 try HEATED DRY---NORMAL---HEATED DRY---NORMAL and then allow the dishwasher to run for a minute or so and then press Cancel/Drain and wait for the dishwasher to stop draining and reset.
Or this Normal > HeatDry > Normal > HeatDry (all lights light up)
Close door. Slide an implement into the gap at the top and press the Cancel button twice.
If you just want to make the dishwasher run, then close the door and THEN press the start button. This makes my dishwasher run.
Good luck.
All times are GMT -7. The time now is 05:12 AM. |