Ask Experts Questions for FREE Help !
Ask
    DJschultz's Avatar
    DJschultz Posts: 2, Reputation: 1
    New Member
     
    #1

    May 5, 2008, 11:15 AM
    My concrete won't dry.
    I did some plumbing in my basement by jack hammering up the floor to install a drain for the shower and sink.

    I back filled the trench partially with gravel and poured new concrete. The trench was 15" wide by 4" deep and about eight feet in length. It's been 3 weeks now and the concrete won't dry.

    Any suggestions? Does anyone know what to do and why it won't dry?
    Tuscany's Avatar
    Tuscany Posts: 1,049, Reputation: 229
    Ultra Member
     
    #2

    May 5, 2008, 11:20 AM
    First off concrete does not dry- it cures.

    Second if after 3 weeks it is still not dry then it was not done correctly. You might have needed more cement (glue that holds the concrete together). It sounds like your mixture was to wet to begin with.
    DJschultz's Avatar
    DJschultz Posts: 2, Reputation: 1
    New Member
     
    #3

    May 5, 2008, 11:30 AM
    Thanks for the lesson. I used Quickcrete ready to use concrete mix and I thought I was VERY conservative on how much water that I used.

    Do you have a suggestion on what I should have used that provides the cement that you indicated in your response?
    shager36's Avatar
    shager36 Posts: 1, Reputation: 1
    New Member
     
    #4

    May 14, 2008, 03:34 PM
    Hi,
    I'm not an expert on cement or concrete or anything really, but I had a similar problem with some quickcrete concrete mix. I had two bags and one cured fine the other was still wet a week later. I removed the wet and tried another bag, mixed it the same as before and it was good in a few hours. Possible you got a bad batch?? Missing something? I'm not sure. Just a thought
    smearcase's Avatar
    smearcase Posts: 2,392, Reputation: 316
    Ultra Member
     
    #5

    May 14, 2008, 06:38 PM
    I have been involved with many thousands of tons of concrete building bridges, roads, sidewalks, light pole foundations, etc etc. I have never heard of concrete not setting after 3 weeks or anything like that. Contractors sometimes have retarders added which delays the chemical reaction, giving them more time to work on bigger pours. Even with way too much water it will usually set within a matter of hours, definitely not weeks. They either left out most of the cement or mistakenly put a chemical retarder into the quickcrete. It is said that adding sugar to fresh concrete will delay set but I've never tried it, and it would be sabotage in your case. Concrete even sets under water.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #6

    May 15, 2008, 11:32 AM
    Try contacting Quikcrete directly and ask them what's wrong? They may replace the product free of charge because I think you'll be digging it out. QUIKRETE® - Contact Us

Not your question? Ask your question View similar questions

 

Add your answer here.


Check out some similar questions!

Concrete Stain on EXISTING concrete [ 3 Answers ]

Hello Professionals! I have a large back yard patio that was laid with concrete during the building phase (1995). The concrete was colored during the pour. To date, the concrete is FADED (I live in Phoenix Arizona and the sun is BRUTAL!! ). I need to re-color the concrete deck and don't know...

Pouring Concrete Slap over Concrete piers [ 1 Answers ]

I drew a fairly detailed drawing of the slab that I wanted, with the piers (flagpole support piers, with pipes down to put poles into) shown so they could do it all in one pour. Well, I guess our general contractor cannot read the drawings because all I got were the piers with the metal in them. ...

Hang concrete plaque on concrete wall [ 6 Answers ]

I hope you can help. I am pretty clueless about these things. I have a big serious retaining wall in the backyard and want to attach an 18 x 24 inch concrete decorative plaque to it. I am afraid of damaging it. Is there a way I can attach something this heavy without drilling? Thanks, Lissa

Pouring interior concrete slab over existing, cracked concrete slab [ 4 Answers ]

I am turning part of my carport into a new living room. I am going to pour a concrete slab about 4 inches thick over the existing carport floor which is a concrete slab. The existing slab has a few cracks, the largest of which is about an 1/8in. Wide and raised about an 1/8in. What would be the...

To concrete or not to concrete [ 8 Answers ]

... that is the question, and here is my situation: I'm getting ready to drop in my Kholer 60" one piece fiberglass shower (no tub) on my basement concrete floor. I've asked two different contractor friends whether or not I should set in concrete. One said definitely, without hesitation. He said...


View more questions Search