Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Safety valve & relief valve
[ 22 Answers ]
What is the difference between safety valve and relief valve
Hot water heater relief popping
[ 1 Answers ]
My problem is the relieg keeps on popping even when I shut down the hot water heater could it be a pressure problem since the water is cold? If so should I install a pressure reducing valve and if so what kind. Please provide any other suggestions thankks
Hydronic heat system
[ 5 Answers ]
I have a 21 unit builiding with a hydronic heat system with zone valves in each unit. Hot water flows slowly in the unit I am in but does not respond to thermostat. Old low voltage thermostat had three wires green red and yellow. Old thermostat was connected with green to the R terminal Red to...
Bleeding Hydronic Baseboard heating system
[ 2 Answers ]
I have just moved into an old house in New Jersey and the house has two separate heating zones: one thermostat upstairs and one thermostat downstairs. The upstairs thermostat is currently inoperative, so a PSE&G technician circumvented the problem, and now both upstairs and downstairs are being...
Hydronic heating system
[ 2 Answers ]
I'm a licensed electrician that's been asked to hook up a 4 zone hydronic heating system which I have never worked with before. It's a mighty therm boiler model HH-PH, using RIB2041D relays 24 volt thermostat and a side wall vent. I've got all the 120 volt hook-up done and the relays hooked in... View more questions Search
|