Ask Experts Questions for FREE Help !
Ask
    ray217's Avatar
    ray217 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 17, 2019, 09:34 PM
    How to read furnace fault codes on a nordyne
    Roof top unit gas pack. Call for heat the inducer starts and so does the blower motor. The unit will not light off. When power is on the red LED has short single flashes. Not on steady. Call for heat and the LED remains the same short flashes. Legend shows 1 flash is limit switch. Tested the roll out and the limit switch all and both together have continuity when tested at the nine pin connector. Does that indicate a bad control board? Control board that I now have is a 624693 Nordyne.

Check out some similar questions!

Nordyne L1RA072C-12A Fault codes [ 1 Answers ]

I need to know the fault codes ( Flashing Colored lights on control board ) for a Nordyne L1RA072C-12A.

Constant blower fault & coil fault messages in Nordyne modulating furnace [ 2 Answers ]

We have continuous blower fault errors messages on IQDrive thermostadt and if we go to furnace, turn off... wait a few min... then turn back on... message Clears, furnace blower will start again and will be OK for about 2 weeks and then same error. Intermixed with this periodically are coil...

Nordyne furnace led codes [ 0 Answers ]

What does an led flashing 4 times mean

Nordyne furnace codes? [ 2 Answers ]

I have a Intertherm Nordyne Model#MMBB-056ABHR-06 gas fired furnace with "NO HEAT". It was manufactured 12/96. The electronic control board is blinking 3 times. Also the pre-blower seems to work right and the board clicks I believe properly. What could be the problem?

Nordyne furnace codes? [ 0 Answers ]

Nordyne model #g4ra072c-12 code lightblinks continiously and the blower motor will not shut off.


View more questions Search
 

Add your answer here.