Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Oil burner short cycles
[ 1 Answers ]
I have a Carlin hot air oil fired system. The burner appears to short cycle when the stat calls for heat. Once the stat calls for heat the burner fires up and runs for a few minutes after the fan comes on. Then the burners shuts down for a few minutes while the fan still runs and fires up again....
Carrier furnace short cycles
[ 1 Answers ]
I have a carrier furnace and when I switch to heat on the tstat the inducer fan comes on then the burners ignite then the blower motor comes on, after about 45 seconds or so the blower motor and burners cut off but the inducer fan keeps running and this process starts again in 10 to 15 minutes with...
Short Furnace Running Cycles
[ 7 Answers ]
My furnace only runs for 15-30 seconds at a time. It will kick off and then fire up 2 minutes later for about another 30-40 seconds. The desired temperature is maintained but the very short on and off cycles are very annoying. We were told it may be our thermostat so we installed a new one and we...
Goodman GMPN060-3 Blower Cycles
[ 2 Answers ]
I have been in my house for 5 years when the thermostat calls for heat, the inducer blower comes on and almost immediately I hear the pressure switch click and then the relay on the main board clicks and the inducer blower goes off. This happens over and over for a couple of minutes and finally...
Furance short cycles
[ 2 Answers ]
I have a carrier 8000 furnace model#58ZAV050-08-serial#3395A20997. In the past ten days the furnace cycles through and run for a while then shuts down.I'm not getting any LED codes. The flame sensor looks good, the high pressure switchseems OK,no indication of a cracked exchanger the flames in... View more questions Search
|