Ask Experts Questions for FREE Help !
Ask
    dselliston's Avatar
    dselliston Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 12, 2010, 12:38 PM
    Furnace stopped working during blizzard. Help??
    I have a Goodman gms9 furnace, my exhaust and intake pipes outside were covered by a snow bank. I cleaned them off and now I have exhaust air coming out and the intake pipe is sucking fine, however, the induced draft blower comes on, but, the electronic igniter does not get hot and the gas does not start, so, the burners never light, I get a flashing led code of six, what else could be wrong?
    jmt4help's Avatar
    jmt4help Posts: 1, Reputation: 1
    New Member
    		  
    #2

    Feb 2, 2011, 12:33 AM
    I have been having the same problem all night. I shut it down and started it back again. Take a little while to heat up but I got to jack it up hot cause it is only holding between 65 and 67 when I have it set at 73. I have been clearing snow every hour since 10 ish pm. Afraid to go to sleep. Tried putting a lawn chair over top so it sort of blocks the drifting
Not your question? Ask your question View similar questions
 

Add your answer here.


Check out some similar questions!

Our furnace stopped working. Circuit breaker OK, new fuses,no power to thermostat [ 1 Answers ]

The furnace just stopped. We checked the circuit breaker, it's fine, replaced fuses, all wiring is tight. The transformer is buzzing so I guess that means there is power, we replaced the thermostat, but there is no power to the thermostat. Any ideas?

Texas furnace stopped working [ 4 Answers ]

Hi I have a Texas furnace I recently changed the circuit board, however it stopped working and the light on the board is not coming on, I checked the power to the unit and everything seems OK. Can anyone help, I live in NY and it is very cold, I would appreciate any help that is our there

Furnace stopped working [ 1 Answers ]

Hi, I am getting 7 red flashes on the status indicator light for my Luxaire furnace, model GM9S060B12UP11G. The Diagnostic Fault Codes indicate "ignition lockout due to retries". The ventor motor starts as do the burners, there are several clicks heard and then the whole thing shuts down. The whole...

Trane Gas Furnace just stopped working [ 2 Answers ]

I have a Trane XL80 gas furnace. It also has a heat pump for ref. Today, the temp in our home dropped and I noticed that the furnace was not working. I opened it up, and vacuumed it out, and have no idea why it started working. All was good! However, hours later, the temp is again...

Furnace stopped working. [ 1 Answers ]

Unfortunately, it seems our furnace stopped working a couple of days ago. I can get the fan to work if I set it to "on" but not "auto". And even if the fan is blowing in the "on" setting, the air never warms up. I've tried playing with the thermostat and resetting the whole thing a few times from...

View more questions Search