Ask Experts Questions for FREE Help !
Ask
    ACPROBLEM's Avatar
    ACPROBLEM Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 23, 2009, 08:10 PM
    Evcon DGAT070BDC want ignite
    I have a Coleman/Evcon sealed combustion downflow gas furnace forced draft with direct ignition (hot surface); I use propane gas.
    The glow rod works and the pilot lights, but the ignition module clicks several times trying to light the furnace flame and then shuts down. It will try again with the same result.
    I have replace the ignition module, the gas valve and the thermostat and still have the problem.
    Any answers?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Oct 24, 2009, 01:13 AM
    Clean the flame sensor with steel wool or sand paper.
Not your question? Ask your question View similar questions
 

Add your answer here.


Check out some similar questions!

Coleman evcon furnace [ 4 Answers ]

Furnace will won't heat. Model #BGMO7516B Serial # 980905038. Red light blinks once. Will ignite but won't kick in to heat.

Coleman Evcon [ 2 Answers ]

My mother has a Coleman Evcon dgat090800 the problem is that the burner will light up on it and burn until the blower kicks on then the burner will quit I can test parts on it but am not positive what the readings should be can someone help.

Evcon [ 1 Answers ]

What is Limit switch open fault code?

Coleman evcon [ 1 Answers ]

Furnace won't ignite the starter blower runs but nothing else happens

Coleman evcon [ 2 Answers ]

Fan won't come on in heat position

View more questions Search