Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Two port valves on a combi boiler
[ 1 Answers ]
Is it possible to fit split heating on a combi boiler with 2 two port valves and a bypass? If not, is there any other way to have independent control of two different areas of a house? Thanks
3 wire thermostat install, heating only, boiler, with automag valves
[ 1 Answers ]
I am trying to hook up a 3 wire (red,green, and white) thermostat. The old thermostat was an automag mercury type that says r+b heat only. All three wires where hooked up. I installed and now my heat will not shut off upstairs. I have 4 zones. I used same thermostat downstairs. Seems to be working...
Cross Reference Honeywell Gas Boiler Valves
[ 1 Answers ]
IS Honeywell Gas Valve # VR8300C4506 the correct replacement for Burnham Hydronics # VR8200C3005 on my Burnham Gas Boiler # P-205-W, s/n 17 115020? Please advise ASAP. Thanks.
Cleaning an Old Steam Boiler & Radiator Vent Valves
[ 1 Answers ]
Hi, I have an old Utica Gas Steam Boiler. Do you recommend using Squick on old boilers as well? What do you know about Gorton venting steam radiator valves? Supposedly, they have a numbering system for each valve based on the location of each radiator in every room in your house. Thank...
No gas supply, or faulty valve in gas fireplace?
[ 4 Answers ]
We use a regency Gr55-3 ~20,000btu gas fireplace for heating our bedroom. Its about 10 years old and has given us no trouble before. The gas supply line is a small (3/8"?) flexible copper tube that runs about 40' from a prv. I believe the prv lets pressure down from 2psi to a few inches of... View more questions Search
|