Ask Experts Questions for FREE Help !
Ask
Page 2 of 2 « First < 2
    dobiefloyd's Avatar
    dobiefloyd Posts: 67, Reputation: 2
    Junior Member
    		  
    #21

    Mar 2, 2009, 06:12 PM
    Hey TXGM

    Thanks for the help, this one has me a liitle stumped too!

    What do you think about the computer? Is it worth throwing a used one at it?

    Thanks

    Ed
    this8384's Avatar
    this8384 Posts: 4,564, Reputation: 485
    Ultra Member
    		  
    #22

    Mar 3, 2009, 09:04 AM

    I don't think the issue is the computer. You're not having any other problems(I assume) and you're able to access the fault code.
    dobiefloyd's Avatar
    dobiefloyd Posts: 67, Reputation: 2
    Junior Member
    		  
    #23

    Mar 4, 2009, 03:45 PM
    Other than the way it runs, no other problems.

    It was a "toss a part at it idea".

    Whatcha throwing?

    But really, why won't the code stop coming up? Sensor is know to be good. The problem has happened with both replacement sensors. I'm assuming all the wiring is good through the harness. Last stop-computer.

    Any ideas?
    dobiefloyd's Avatar
    dobiefloyd Posts: 67, Reputation: 2
    Junior Member
    		  
    #24

    Mar 6, 2009, 03:22 PM

    Bump
    this8384's Avatar
    this8384 Posts: 4,564, Reputation: 485
    Ultra Member
    		  
    #25

    Mar 6, 2009, 03:41 PM

    I don't know... you're positive all the fuses are fine and that there's not one for the heater element?
Not your question? Ask your question View similar questions
 
Page 2 of 2 « First < 2

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

MAP sensor;Mass Airflow sensor;Volume Air sensor-All Same? [ 8 Answers ]

97 Nissan Pickup - 160,000 miles - KA24E engine -Check engine Soon Light Code reader says volume air sensor. Is this the same as a mass airflow sensor or the MAP sensor? Where is this sensor located, in the throttle body injection? Just threw a new O2 (Bosch)sensor on it, I lost that bet.. it...

Mazda Protégé 2000, Hesitating and stalling [ 2 Answers ]

I have a 2000 Mazda Protégé that after driving it for about 10 minutes staedy will start hesitating and when I stop at stop lights it boggs down and will cut off if I don't ride the clutch and gas. I have had it to 3 different mechanics and have had a mass airflow sensor and new air hose put on....

1989 honda civic. (code 4)crank angle sensor.(code 8) tdc position sensor [ 0 Answers ]

The car idles randomly after warm up.I check the ecu for codes and it gives 4 crank angle sensor and 8 tdc position sensor. I did a search and one of the ad posted by a guy in Canada says that he had to get part from different vehicles until he got all of them to work properly. Will I be able to...

View more questions Search