I am currently in the process of removing 2 fluorescent lights in my kitchen and going to be replacing with 1 unit. As far as the wiring for the other component that is not going to be used what do I do with it? Would I just cap the wires and leave it be or what? Any help would be greatly appreciated.

That's exactly what I've done in the past and it has been fine (for years). I simply cut back the ends of the wires (Make Sure the breaker is OFF! And you've tested for any current first!) and then screw wire nuts onto each wire. Next, I wrap each wire with electrical tape to secure the wire nut and that's it.

Thanks for the quick response. That is what I will do!

No problem... like I said, you shouldn't have any issues, and I've even drywalled / patched the old location. And the house is still standing 15 years later! LOL

If you don't mind, if you would rate my answer I'd certainly appreciate it!
Thanks

Most electric codes do not permit a electric box with spliced wires to be buried behind walls or ceilings. While it may be fine with no problems for many the selected few may experience problems in the future with shorts and possible fires. Wires should be removed by someone who is familiar with electric codes in your area

Very good point about following electrical codes. You can always do the wire nuts / tape part and then finish with an approved cover plate - and Not plaster over the plate.
I'd have to grab an NEC book, but that would probably be acceptable. And I'm sure a licensed electrician would tell you what codes apply in your area.
Safety is always the first concern.

It may be a simple issue, I'm sure above the ceiling there is just a wire running between the 2 lights. Is it possible to get above the ceiling and remove this wire?

If the wire is live, then burying the wires is not allowed, and the junction box would need to be accessible. If dead and is permanently disabled, then taping well and burying in a box is fine. Do note that code does not require abandoned wire be removed completely where possible without causing any damage.


This is a basic requirement of electrical code, and all local codes will follow.

They make a round, near flush cover, and no screws showing. Can be accessed later.Its plastic. Don't bury
If the one you want to delete has only one set of wires. It goes to other light.
Then see if you can unscrew box from stud, loosen locknut at other box, and give a light pull. If you can, remove wire Plug knockout and patch ceiling.

Also. Its cheaper to leave it, than to put it back later.