PDA

View Full Version : Running water sound in water pressure tank


CNYBrian
May 1, 2007, 07:13 AM
Not sure if I have a bad bladder in my water pressure tank but here is what I have. When my submersible pump kicks on I hear what sounds like water and air mixing in the tank. The house pressure comes up to about 50 PSI and takes time to bleed down. Could I have air in the tank from the well vice a bad bladder? How can I be sure? Please help!

speedball1
May 1, 2007, 07:40 AM
Let me explain the function of a bladder tank. Pressure and bladder tanks provide a air cushion that produces water pressure in your system so your pump doesn't kick on every time you draw a glass of water. A bladder tank has a neoprene membrane in the center. As the pump puts water into the bottom half of the bladder tank the membrane compresses the air in the top half. When the pressure reaches the cut off point in the control box the pump shuts down. However you still have between 40 to 50 pounds of pressure pushing the water out to your system. As the pressure drops in the tank when you make a draw the pump kicks on and everything starts over again.
To check, take something metal and start rapping at the bottom of the tank and work upwards. You will hear a "clunk" in the bottom half full of water. On the upper half you should hear a "clink" because the upper half should have nothing but air in it. IF the sound doesn't change or changes close to to tank top then the bladder tank must be replaced. Your air setting on the tank should be 2 pounds UNDER the cut in point in the pressure control box. If your pressure control has a 20 PSI cut in and 40 PSI cut out the tank pressure should read 18 PSI. This should be done with the pump off and no pressure in the system. Hope this helps Regards, Tom