Replaced control board and when it started up it shows f01 after about a miniute of running . Maytag bravo

Maytag F01 code is control board (typical code for most washers and dryetrs). Unplug the unit, wait 5 minutes and retry. Was the washer unplugged when you changed the board?

You have another problem other than the control board. Check the filter screens on the water valves at the back of the machine, first. Here is a manual: https://dl.dropboxusercontent.com/u/142419/Maytag%20Bravos%20Washer%20with%206th%20Sense%20Te chnology.pdf
You could have a bad pressure sensor, too.