Have Kenmore Ultrawash quiet guard 1. It stopped after the wash cycle and just has blinking NORMAL WASH button. Model 665.15632
I was able to push Cancel/drain and it emptied. Tried to run again on Normal wash and washed and came to same point. Blinking light
I tried turning off the circuit for 5 min. No luck
How can I reset?

Several articles describe the reset process, like this one,

Kenmore Ultra Wash Diagnostic Code Reset – Clean Light Flashing - GinormaSource Home (http://ginormasource.com/home/kenmore-ultra-wash-diagnostic-code-reset-clean-light-flashing)

And some helpful videos to guide you, starting with this one,

https://www.youtube.com/watch?v=nX-rxbvW57Q

And followed by others that are very instructional. (See list on the right, but they run automatically)