Maloysius
Jan 8, 2015, 08:47 AM
Hello,
I have a gas furnace It is a peerless 61-05-STDG-S. Every week or so, I have to go into the basement and make sure to add water too it because it shuts down if it runs out. Well it must have been colder than normal because it ran out faster than it usually does. So now the heater is completely off. First off, I thought it was the pilot, but turns out that is still lit. So I researched a little bit last night and some things I tried so far are I tried turning the thermostat off, the breaker off, and the switch above the furnace off and turned them back on. Even tried just breaker and thermostat or switch and thermostat. I did try to give each a few minutes as well before turning them back on. Nothing also when I have power to it, and try to turn it on from the thermostat, it sounds like it is firing, but nothing happens, usually you can hear the fans come on. The firing doesn't seem as regular though, usually it would go with every turn of the thermostat but it doenst seem to be doing it. Any help would be greatly appreciated!
I have a gas furnace It is a peerless 61-05-STDG-S. Every week or so, I have to go into the basement and make sure to add water too it because it shuts down if it runs out. Well it must have been colder than normal because it ran out faster than it usually does. So now the heater is completely off. First off, I thought it was the pilot, but turns out that is still lit. So I researched a little bit last night and some things I tried so far are I tried turning the thermostat off, the breaker off, and the switch above the furnace off and turned them back on. Even tried just breaker and thermostat or switch and thermostat. I did try to give each a few minutes as well before turning them back on. Nothing also when I have power to it, and try to turn it on from the thermostat, it sounds like it is firing, but nothing happens, usually you can hear the fans come on. The firing doesn't seem as regular though, usually it would go with every turn of the thermostat but it doenst seem to be doing it. Any help would be greatly appreciated!