Ok I am replacing a condenser fan motor for a home unit. It has been replaced before about 2 years ago. It's a dual cap system. It has a new cap with the new motor. Here is my problem. The motor has 5 wires white, red, black, brown, brown/white. When it came apart I did not see where the white wire went. The black and red where wire nuted to an original connector. The white might have been tied to the red I just didn't see it. I need some help figuring out where the wires go. I think this is how it should go. Black T1 White T2 brwn and brwn/wht to cap. Red is low speed and not used. I don't think it should have been connected to the line. Can anyone tell me if this is correct?