About a week ago a pipe burst behind the washer and the console for the washer got soaked. After letting it dry for several days, we are able to use the machine, but it does not agitate in "Heavy duty" or normal modes.

How can I fix it?

Here are some manuals that will tell you what you need to know: https://dl.dropboxusercontent.com/u/8010163/Understanding%20automatic%20washer.pdf
https://dl.dropboxusercontent.com/u/8010163/Whirlpool-Kenmore%20washers.zip
https://dl.dropboxusercontent.com/u/8010163/Whirlpool%20Washers.zip

Tom,

I got the schematic from under the control panel and it does not show "spin/agitate" solenoid.

It seems (as best I can determine) that circuit 19 is the agitate circuit and it appears to be fed from pin 2 of the balance switch?

I do hear the motor running during the wash/agitate sequence and then the drum goes into rinse ad spin properly, but no agitate in either wash or rinse sequences.

I'm wondering if may be a mechanical problem as opposed to electrical. My thinking is that if a sensor, switch or solenoid were involved, the motor would not run, at least that's the way the schematic reads.

Don

Follow up-

The failure was the dog bones! It was just coincidence that the problem happened after the back of the washer was flooded.