Reset this dishwaser once before but cannot find the sequence now.

Step one: Hold "Normal Wash" and "Start" together for 10 sec.
Step two: Press "Air Dry" and "High Temp Scrub" back and forth until "Quick Rinse" button turns on solid.
Step three: Press "Normal Wash" again followed by "Start."
Step four: Let machine run until you see green "Clean" light come on.
Step five: Press "Normal Wash" again and "Start" again.

Step one: Hold "Normal Wash" and "Start" together for 10 sec.
Step two: Press "Air Dry" and "High Temp Scrub" back and forth until "Quick Rinse" button turns on solid.
Step three: Press "Normal Wash" again followed by "Start."
Step four: Let machine run until you see green "Clean" light come on.
Step five: Press "Normal Wash" again and "Start" again.

This did not work. Will try again. I do not know if it helps, but the "Quick Rinse" light is currently flashing.

Look at these: https://dl.dropboxusercontent.com/u/8010163/Kenmore_Ultrawash_Dishwasher.pdf
https://dl.dropboxusercontent.com/u/8010163/Whirlpool_Dishwasher_Service_manual.pdf

Did you ever figure out what was wrong with your unit. Mine is doing the same thing.