Fascia Board Replaced. I took the measurements. 68" long, 7" wide
3/4 " thick. I just hope I do not have to rip the board. Cross cut is no problem. I wonder what the best size is and is available?

1x6, 6 ft long. 1x6 is 7 1/8 to 7 1/4 and should be what you have as it is a common size.

Very Good

1 x 6? Don't you mean 1 x 8?
It would have to be ripped. Attach a small length of wood onto the board as a straight edge. Two little nails would hold it enough for a circular saw.

joy is right. It would be a 1 x 8.

Cut the length you need and check to see if it is longer in width then existing fascia. It very likely is the same size.

Chuck

1 x 6? Don't you mean 1 x 8?
It would have to be ripped. Attach a small length of wood onto the board as a straight edge. Two little nails would hold it enough for a circular saw.

DUH 1X8 is correct. May not have to rip depending on roof edge. Builders like to use a std. size and not rip. Sometimes they will cut a bevel at the top to match the roof slope.