PDA

View Full Version : Water enters washer after cycle completed


Wade6
Jul 11, 2013, 10:34 AM
My front-end-load clothes washer works fine but after the cycle is completed water will enter the washer - a few inches over several hours. This happened last year and then stopped until now.
I suspect the inlet valve isn't closing properly.

Thanks for any help.

hkstroud
Jul 11, 2013, 12:04 PM
I suspect the inlet valve isn't closing properly.

I suspect that you are right.

Remove, disassemble, clean, lubricate and reassemble. If problem persist replace.

drtom4444
Jul 12, 2013, 06:20 AM
It's best to soak the valve parts in Lime Away or vinegar, but not the solenoid coils. Look carefully at the pin and spring that goes in the solenoid tube that is located in middle of solenoid coil. That's what you see sticking up when you remove the coils. If the pin is worn out you may need to replace it or the valves. The diaphragm is what actually stops the water flow and it can get stiff with age (especially the hot water side) or the orifice can get stopped up with lime. Here is a manual that may help: https://dl.dropboxusercontent.com/u/8010163/Understanding%20automatic%20washer.pdf Good Luck.

Wade6
Jul 12, 2013, 09:45 AM
Thank you both for the advice. I will give it a try.