I have hot water baseboard heat, and installed the hunter digital thermostat 44110, and followed the directions as directed, I had had wires W, Y and RH, I marked and installed
Each of the wires, and put them where they were marked on the thermostat.

I felt well and all of the lights ( temp, time, etc) lit up and Iwas happy. UNTIL two hours later when I found the heat unusually high, 78 degrees, I checked the pre-set and it showed 68 degrees, and I did all I could to circumvent the problem, but to no avail, so I re-installed the origonal thermostat, I would appreciate any advice as to how to use this thermostat (Hunter).

Thank you
Vicki Hunt

Here is the manual, did you follow the directions on page 4? www.hunter-thermostats.com/manuals/44110.pdf In some situations a jumper must be installed between Rh and Rc. This thermo should work with your basebpard system.

You owe it to yourself to contact Hunter.com I had what I thought was problem and it turned out to be simply the wrong model. I now have the correct model for my application and I love it.