Log in

View Full Version : Toilet flushing problem


concat1
Jan 13, 2013, 07:01 AM
The main floor toilet when flushing spin in a whirlpool fashion however does not take any of its contents down with it. However after a few flushes it will take it down in a very strong pressured pull. This happens more frequently now even with one sheet of paper in it. Please help!

hkstroud
Jan 13, 2013, 08:22 AM
What happens if you hold the flush leaver down during first flush?

concat1
Jan 22, 2013, 09:36 AM
What happens if you hold the flush leaver down during first flush?

Sometimes this will fix the problem but not always

hkstroud
Jan 22, 2013, 11:27 AM
Check the water level in the tank.

concat1
Feb 2, 2013, 09:01 AM
The water level appears right but it's not that I know that for sure? Is there a way to tell the best level.

concat1
Feb 2, 2013, 09:07 AM
The water level appears right but it's not that I know that for sure? Is there a way to tell the best level.

ballengerb1
Feb 2, 2013, 04:39 PM
You tank water level should be no lower than 1/2" below the top of the over flow tube.

hkstroud
Feb 2, 2013, 04:48 PM
Should also have a water line mark on the inside of the back of the tank.

concat1
Feb 2, 2013, 04:51 PM
Should also have a water line mark on the inside of the back of the tank.


Yes water line is just slightly above line

Firsthome
Feb 4, 2013, 08:50 PM
I had the same problem and I ran a snake down 25'. Works great... for now. Auger-style 25' snake ran me about $15.

ballengerb1
Feb 4, 2013, 08:52 PM
Snaking a toilet requires the toilet to ome up off the floor. Before you snake you should try vigorous plunging. Plunging gets it power on the pull stroke not the push.

Firsthome
Feb 4, 2013, 09:37 PM
Glad you mentioned that,ballengerb1. After pulling mine I reset it with a reuseable foam-like ring instead of wax. Found it at a small local HW store. I'd never seen one before.

concat1
Feb 5, 2013, 04:26 PM
Thanks I'll try the snake... it can't hurt!

ballengerb1
Feb 5, 2013, 04:56 PM
Concat, that isn't what I recommended, plunging is easier and frequently does the trick

concat1
Feb 7, 2013, 09:37 AM
Sorry my mistake,However plunging has not worked for me, however previously hkstroud suggested I hold down the handle during the entire flush and 8/10 times it works best. So that will have to do for know. Thanks for all your advice

hkstroud
Feb 7, 2013, 03:01 PM
hold down the handle during the entire flush and 8/10 times it works best

That was a diagnostic step.

If holding the flush lever down makes the toilet flush properly, that suggest to me that the water level in the tank is to low or the flush valve is defective and closing to soon. Since you have previously said that the water level is at the water mark I suggest looking at the flush valve. What type do you have?

Do you have a large hole (jet) at the bottom of the toilet?

concat1
Feb 8, 2013, 10:20 AM
Yes it does have a large jet at the bottom of toilet. The toilet is an American Standard roughly 8 years old.