00RWOW
Dec 6, 2012, 05:15 PM
Put in a new crank sensor and a new dist, rotor turns please help!
TxGreaseMonkey
Dec 6, 2012, 06:19 PM
. Remove and fully charge the battery. Clean the battery terminals and cable connections. Clean the ground cable, where it attaches to the body of the car.
. Check for codes.
. Check all under hood and under dash fuses with a test light or multimeter. This may lead you to suspect the ignition switch.
. Clean the main PCM ground, after disconnecting the negative battery terminal.
. Check/replace the Camshaft Position Sensor. I've seen many of these sensors fail on Nissans.
Did you install a new distributor made by Nissan?