My Kenmore 80 series washer purchased in 2006 does not completely fill water in the Rinse cycle. It is OK in the wash cycle, but when it gets to the rinse cycle, it only fills about 60% and it stops. I had to manually push the knob to stop and then turn the knob to like I'm going to start all over again, but I go straight to rinse cycle. That's the only way to get the washer going again, it finally fills up with water and goes through the rinse and spin cycle no problem after this manual intervention. But sometimes also it takes a very long time to fill with water and we have good water pressure in the house.

It is so inconvenient to keep going to the garage, especially when you have many, many loads of laundry.

Has anyone experienced this problem before? I am disappointed with this Kenmore series 80, as we had older Kenmore from 2003 (purchased for my mother & father) and it is still working fine.

Thank you so much in advance for your help. Miss Stella