PDA

View Full Version : Ants in Water Pump Switch


bones252100
Oct 29, 2012, 06:12 PM
Ants ( & lizards ) keep getting getting into the pressure switch & fouling the contacts. Removing the pests are easy enough but prevention is a better answer. This is in Florida which has always been the insect capital of the US. Any ideas for prevention would be appreciated.

hkstroud
Oct 29, 2012, 07:02 PM
Tape, caulk or silicone where electrical wires enter the switch to seal. Wrap a couple wraps of electrical tape where cover meets the base. Remove cover hold down nut and put a small "O" ring on shaft to seal. That should give you an air tight switch compartment.