How to remove transmission range sensor?

It should be like the procedure below:


How-to Remove and Install a Transmission Range Sensor (TRS)

The Neutral Safety Switch is part of the TRS.


Removal:

1. Disconnect negative battery cable.
2. Place gear selector in Neutral (N).
3. Remove air cleaner and air cleaner outlet tube, if necessary.
4. Disconnect TRS electrical connector.
5. Remove manual control lever from transaxle.
6. Remove TRS retaining bolts (2).
7. Remove TRS.

Installation:

1. Ensure gear selector is in Neutral (N).
2. Install TRS and loosely install both retaining bolts.
3. Align TRS slots using TRS Alignment Tool.
4. Tighten TRS retaining bolts 9 to 12 Nm (80 to 106 inch-lbs.) and remove tool.
5. Connect TRS electrical connector.
6. Install transaxle manual control lever--tighten 11 to 16 Nm (98 to 141 inch-lbs.).
7. Install air cleaner outlet tube and air cleaner.
8. Connect negative battery cable.
9. Check for proper operation with parking brake on. The engine should start only in Park (P) or Neutral (N).

Ford 2000 exp 4.6 with tra nsmission problems

Change filter new fluids, silenoid switch
Drove forward it stopped moving put it in reverse and it moved but will not move forward only in reverse. Is there a fuse to change to solve problem?

King, focus on the TRS.