I have installed a whirlpool tub. All the 6 side jets worked fine and it is completely level. Now (since it is all in and attached) two of the side jets on the same side are not working. (The tub only has six jets total-three on each side.) One has poor water flow and the other sucks in air. I would like to fix this without tearing down the wall, etc.

I have installed a whirlpool tub. All the 6 side jets worked fine and it is completely level. Now (since it is all in and attached) two of the side jets on the same side are not working. (The tub only has six jets total-three on each side.) One has poor water flow and the other sucks in air. I would like to fix this without tearing down the wall, etc.
Is it possible you pinched the hose when installing? It sounds as if at least a portion of the install may have to be dismantled to correct this.