View Full Version : Tecumseh tvm220
luckyrabbit7
Aug 11, 2012, 12:18 PM
I put a tecumseh tvm220 engine in my craftsman lawnmower. It powers the mower fine, but I don't know how to kill the engine once its started. I pulled the spark plug wire. The engine only has two wires coming from the charging coil.
Any ideas?
Thanks jim
ma0641
Aug 11, 2012, 12:38 PM
Use choke to kill it or make up a ground strip to push against frame. That's how they did it years ago.
luckyrabbit7
Aug 11, 2012, 12:52 PM
I tried the choke before, but it makes it hard to restart.
ma0641
Aug 11, 2012, 03:56 PM
Get a piece of wire and put it under the spark plug cap nut. Now go get a door push button and connect the wire to 1 side and ground the other side. Push button to stop
crigby
Aug 12, 2012, 10:15 PM
Hi,
Give me a break. There is a ground spade on the coil that should have a wire attached to it and coming from beneath the shroud(usually white.) It should attach to the harness at some point and go to the switch. Wire could be broken, disconnected or switch ground bad. The manual link is here:
http://outdoordistributors.com/pdf/Kohler/KOHLER-CV15S-41525.pdf
It is fairly large, so be patient.
Peace,
Clarke
luckyrabbit7
Aug 16, 2012, 10:22 AM
Thanks clarke
You were right. There was a wire coming from the shroud. It was a green wire. I thought it was a ground wire, but looking at it closer, it had insulating material under the spade. When you ground it, it kills the engine. I hook it up to the wire from the key switch and everything works as it should.
Thanks again jim