I'm replacing a kitchen light with 4 pot lights.

The existing light was Power->Light->Switch

To save ripping my entire ceiling down, I want to wire as follows:

Power->L1->L2->Switch->L3->L4

Is this possible and/or permissible? I have it wired like this now but when I turn the switch to on, the lights are nowhere as bright as they should be. When I started removing lights from the circuit (L3 & L4 initially, then L2, L3 & L4) the light output got brighter (what seemed to be twice as bright then full brightness respectively).

Hopefully I will be able to accomplish my lighting task without too much damage to my existing ceiling.

Thanks.

You can only do that if you have a 3-wire cable between L1 and L2.

Thanks Harold.

How would the wiring connections be done with the 3 wire?

..

Thanks very much Harold.

One further question; what if the wires for light 3 & 4 branch from light 1 instead of L2? It's a bit of a convoluted mess but it was my only option other than tearing out a bunch of ceiling?

..

Thanks for all the help Harold. This worked perfectly and now my lights are as bright as intended.

Harold's sketches and drawings are, to say the least, outstanding.

Just a comment to the installer, when a white wire is used to feed power to a switch, called a switch loop, the white wire needs to be re-identified as a hot, usually black marker, or at least black tape.