I replaced the coil in the distributor, the main relay and Im still not getting a spark from my wires or getting any fuel threw lines. Any advice where to start next:-)

Replace the Ignition Control Module (ICM). Apply silicone heat transfer grease to the back of the new ICM. This is the ideal time to also replace the distributor cap and rotor, which often cause ICMs to fail when they are worn.

Verify that the Check Engne Light consistently comes on for 2 seconds and then goes out, when the ignition switch is turned to ON (Position II). During this 2 second interval, you should hear the fuel pump in the gas tank run.