blackbear
Feb 7, 2007, 08:06 PM
Hello!
I have 2 3-way motion sensor switches I want to install in my garage. There currently are two 3-way switches on different walls.
The setup is different from another thread I was reading on this site.. .
In my case the power (2 wire w/ground) goes to the light, and each of the switches 3 wire w/ground also comes to the light.
Therefore each switch box has a ground, black, red and white.
How would I would I wire two 3-way motion sensors so that they are not switching off as I walk from one to the other?
Thanks,
Bill
I have 2 3-way motion sensor switches I want to install in my garage. There currently are two 3-way switches on different walls.
The setup is different from another thread I was reading on this site.. .
In my case the power (2 wire w/ground) goes to the light, and each of the switches 3 wire w/ground also comes to the light.
Therefore each switch box has a ground, black, red and white.
How would I would I wire two 3-way motion sensors so that they are not switching off as I walk from one to the other?
Thanks,
Bill