TheHappyFriar
Sep 5, 2011, 03:25 PM
This is in a manufactured home that was put up in the end of 2008 so the toilet it relatively new.
When I flush the toilet it goes down slowly. Water tank fills up ~1/2" from the top of the overflow pipe. None of the holes around the inside of the toilet are clogged. I can't find any clog/blockage in the jet hole. Can't find anything in the drain pipe or the air pip on top of the house. Both the sink and bathtub in the same room drain fine and the toilet, tub and sink in the other bathroom drain fine.
I checked the pressure with my hand of the water coming out of the jet hole. It stops a few seconds after the flapper closes. By that time the toilet is still swirling but it's not going down. I checked the jet hole pressure in the working toilet and it had pressure until the water was gone from the bowl.
So I've got to figure out why the jet hole is losing pressure and need to get it back up. Any ideas?
When I flush the toilet it goes down slowly. Water tank fills up ~1/2" from the top of the overflow pipe. None of the holes around the inside of the toilet are clogged. I can't find any clog/blockage in the jet hole. Can't find anything in the drain pipe or the air pip on top of the house. Both the sink and bathtub in the same room drain fine and the toilet, tub and sink in the other bathroom drain fine.
I checked the pressure with my hand of the water coming out of the jet hole. It stops a few seconds after the flapper closes. By that time the toilet is still swirling but it's not going down. I checked the jet hole pressure in the working toilet and it had pressure until the water was gone from the bowl.
So I've got to figure out why the jet hole is losing pressure and need to get it back up. Any ideas?