PDA

View Full Version : 1996 accord


klamathayers
Jul 16, 2011, 11:05 AM
I have a 1996 accord that cut out when it rev up to 3000 rpms. Like a governor it has the 2.2 non v-teck I just put in new rings bearings water pump timing belt head gasket has the vavles and seats done and had the head shaved.

cdad
Jul 16, 2011, 12:41 PM
Did you do the work or was it done by a professsional ?
You may have set the initial timing off when you made all the changes. Also did you inspect the valve springs ? Have you run a compression test yet ?

klamathayers
Jul 16, 2011, 03:47 PM
Yes I have done the work myself. I did run a compression test and Im getting 120 on all cylinders, which I believe is low. I had a machine shop do the head, valves and seats. After I made all the changes I drove it fine without any of these problems about a mile down the road the car would stall at 3000. I also noticed last night approx. every other time I tried to start the car it would act as if its not getting gas.

klamathayers
Jul 16, 2011, 03:48 PM
I also just cleaned my iacv, fitv, and tb. Which did fix my irratic idling