PDA

View Full Version : Swimming Pool Replacement Parts?


jaydee524
Jun 11, 2011, 01:08 PM
I need to change the vinyl/plastice caps that are located at each support column. They used to be secured with a screw, but a few years back I found plastic ones that just snap on. Any ideas?

Thanks

chaosmaster1
Jun 12, 2011, 07:17 PM
Can you describe your pool to me? I assume that you are referring to a above ground pool? Is there anyway that you could show me a picture of the parts you need to replace?

jaydee524
Jun 14, 2011, 04:36 AM
It is an above ground pool. There are posts set up up every 5 to 8 feet which the rails are attached. Then you have caps that are on top of this. The original ones that came with the pool were secured by a screw. The replacement ones that I bought around 4 years ago snapped into place. But I cannot fin where I bought them from

chaosmaster1
Jun 14, 2011, 07:13 PM
Do they have a part number on them. If you can give me a part number or name of the parts any writing on the parts would be helpful