anchient_age
May 3, 2011, 07:14 PM
I recently had to replace my 1992 3 ton Goodman heat pump... the air handler was replaced as part of the deal. I kept the old air handler, took the 'A' coil out of the bottom, cut the housing off to make it shorter and added a stand with filter to the bottom. I put duct work bending the air so I can use it as a fan in my workshop in summer and a heater in winter. My problem is getting a switch rigged up so I can run the fan only or the fan and the heater coil. Running 220 volts to the main power block is not a problem, but I have a brown, red and two white wires that went to the thermostat. This is where I'm needing help. I plan to use a 3 position switch, Off, Fan, Fan & Heater. Can you suggest which wire goes where? Thank you!