Grohe Ladylux installation instruction

I believe that model has a single nut that tightens an anchor plate. You will need the installation tool or a deep socket with an extension. Look at the bottom of the faucet and you should see the nut. Tighten turning right.

Show us a picture of the faucet and the nut under the counter top.

Hi all:

There are 3 or 4 different Grohe ladylux faucets on the market, but the ones I have worked with tighten from the top.

Here, remove the spout assembly by lifting hard on the spout and then loosen the spray head and set it off to the side.

Push the spray hose through the spout and down past the threaded column and then tighten the threaded column CLOCKWISE until the faucet is tight.

Pull the spray hose up through the spout and attach the head again and then push the spout back down and into place. If you have a plumber's grease then this is a good time to regrease the plastic swivel parts.

If this doesn't work for you then let us know the exact model of ladylux you have as it could be a little different than as described (but I doubt it), OK?

Let us know how you make out... ;)

Mark