PDA

View Full Version : I had a busted pipe and now I have no hot water


kp12345
Feb 3, 2011, 06:31 PM
We had satellite internet installed today and the installer went to deep digging a hole for the support pole. He hit a waterline. We had to turn off the water to fix the pipe and now we have no hot water. Why?

massplumber2008
Feb 3, 2011, 06:46 PM
Hi Kp...

Cold water is fine, but only the hot water is an issue? If so, close the cold water shutoff going into the water heater and then reopen it... may dislodge sediment that may have gotten caught up in the shutoff which could certainly shut the hot water down.

Try that and then let me know what happens. I'm in and out over the next couple hours, OK?

Also, let me know if you have all single handle faucets or if some of your faucets/valves have two handles...

Mark

ballengerb1
Feb 3, 2011, 08:39 PM
I am sure Mark can help you out but I am wondering why you did not hire a plumber to fix this and then bill the satellite guys. They broke it they fix it. You should not have to lift one finger, other than to dial the phone

massplumber2008
Feb 4, 2011, 05:08 AM
Good point, Bob... good point!