PDA

View Full Version : Power goes out in part of house w/out tripping breaker Part 2


Gbrown
Dec 24, 2006, 12:09 PM
How would I use a voltage tester? Would I go from outlet to outlet measuring the voltage? I've gone around the house and tightened outlets and opened the panel and tightened the screws that were not tight.
I haven't seen the lights dim since I tightened everything.
Thanks a lot!
Gbrown

tkrussell
Dec 25, 2006, 06:31 AM
Using a voltage tester I should have said to use a volt meter, something that measures voltage accurately, not just sense voltage. Measuring the actual voltage would help with identifying parts of the circuit that are being affected.

Knowing exactly where the loose connection was found would have my preference, so as to be sure the fault was definitely found, and not hoping.

Monitor the flickering lights to be sure it does not occur again. Did tightening the connections also stop the power from shutting off in the area as you mentioned?

Gbrown
Dec 27, 2006, 10:14 AM
Using a voltage tester I should have said to use a volt meter, something that measures voltage accurately, not just sense voltage. Measuring the actual voltage would help with identifying parts of the circuit that are being affected.

Knowing exactly where the loose conection was found would have my preference, so as to be sure the fault was definitely found, and not hoping.

Monitor the flickering lights to be sure it does not occur again. Did tightening the connections also stop the power from shutting off in the area as you mentioned?

I haven't had a flicker since I practically went through the whole house tightening outlets, pulled the cover off the circuit breaker panel and tightened a lot of things, put proper bulbs in lamps, found one very bad lamp, couple of outlets that were -polarity etc. Haven't had a power outage or flicker since I last wrote to you.
Thanks for the advice!
PS got a new multi-meter for x-mas out of the deal pretty good eh?
Greg Brown