View Full Version : How to find TDC on a 1991 honda accord
artoro
May 15, 2010, 09:31 PM
I removed the distributor and the wires ,now is all messed up,how do I find TDC and the firing order,how to set this straight again? Thanks
thejohnlennon1
Apr 30, 2012, 10:48 AM
The firing order on a 90-93 accord as far as I have seen because I have a 92 accord is 1-3-4-2 the wires set from front of engine also the tdc can be checked by removing spark plug 1 and placing a long screw driver or the oil dipstick and checking to see whrn it stops. Also on the driveplate in frontbof the engine there are several marks. I believe it has to be aligned with the white mark. Unsure about the last part
Stratmando
Apr 30, 2012, 10:57 AM
The following is Generic, good for Most:
Have someone crank engine with cap removed to determine direction of rotation.
Verify Firing Order.
If you use the dipstick in the plug hole to find TDC. You could be 180 degrees out, due to the fact you need to be TDC on Compression Stroke.
In that case, if it doesn't work, swap adjacent wires(if it was on exhause stroke, it will now be compression stroke), should work if you are close.
Why did you remove the distributor?
I would also buy the service manual if you like and plan to keep this car, It will save you money and Time, if you or someone else works on the car.
Good Luck.
Stratmando
Apr 30, 2012, 11:05 AM
Cylinder #1 is where the alternator is.