View Full Version : In a 160 ft. Deep well with a submersible pump, pressure has gone from 60 to 45 psi
howard424
Apr 17, 2010, 06:08 AM
Water pressure began to degrade about 2 week ago the pump continued to run with pressure switch at 60PSI, reduced pressure switch to 55 ans it was OK, after 1 week pump could not achieve 55PSI. I dropped the pressure to 50PSI. It continues to degrade. Does this sound like a bad pump?
hkstroud
Apr 17, 2010, 06:21 AM
Suggest trying simple and least expensive things first.
Remove pressure switch and insure that port is clear and clean. Could be a restriction causing inaccurate readings.
speedball1
Apr 17, 2010, 07:37 AM
This could also be the impeller going bad. Any dark particles in the water? Remove a aerator and check then screen. Good luck, Tom
jlisenbe
Apr 17, 2010, 09:33 AM
It does sound like a bad pump. Could be your gauge is not reading right. Make sure your pressure gauge is good. It such read about the same pressure you get with a tire gauge at the top of the pressure tank. But, that's a stretch. Even if you had restrictions in pipes, that would more affect volume than pressure. I would do as HK suggested, which is to check the little pipe leading to the switch. As he pointed out, it's a cheap fix, but don't pin too many hopes on it.
howard424
Apr 23, 2010, 06:43 AM
Thanks for the advice. It turnrd out to be 2 holes in the galvanized drop pipe
speedball1
Apr 23, 2010, 06:46 AM
Thanks for the advice. It turnrd out to be 2 holes in the galvanized drop pipe
We thank you for the update. Tom